|
| kato |
|
||
|
I recently put a 1/2" phenolic spacer & 65mm AU throttle body on my EF everything went well, I swapped my ISC & TPS sensors & put them on the AU T/B, car is going great, pulling strong, the only drama i've got is sometimes I get this surging idle where the engine will surge up to 1500rpm then drop back to 400rpm it will go up and down until it stops, i've set base idle it improved it a bit but still playing up any ideas??
Thanks Josh
_________________ EF XR8 5spd: 302ci /178rwkw |
||
| Top | |
||
| Falcon96kickass |
|
||
|
ICU is stuffed
_________________ Your all a bunch of f**k Heads delete this f**k account stupid useless C*** who run this site cant even sell something useless wankers |
||
| Top | |
||
| xf84 |
|
|||
|
sounds like u have a bit of a vacuum leak possibly. this also happened to me. I would try resetting computer also with those mods (if u havent already done so....)
_________________ Old - XF with XH XR8 Driveline... {DESCRIPTION} |
|||
| Top | |
|||
| XH5LWEPN |
|
|||
|
Checked TPS voltage? What have you set base idle to and how?
_________________ STREETBUILT RACING |
|||
| Top | |
|||
| kato |
|
||
|
Haven't checked tps, I set base idle by following the directions in repair manual, disconnect isc plug, let motor idle for 1 min, then adjust idle with t/b screw, switch off then plug back in and restart??
_________________ EF XR8 5spd: 302ci /178rwkw |
||
| Top | |
||
| XH5LWEPN |
|
|||
|
{USERNAME} wrote: Haven't checked tps, I set base idle by following the directions in repair manual, disconnect isc plug, let motor idle for 1 min, then adjust idle with t/b screw, switch off then plug back in and restart??
s**t well if you havent reset your TPS to the right voltages i would say thats the problem. Obviously you had to make a few mods to the TPS holes and the T/B blade for it to fit, but you will most likely have to elongate the holes on the TPS so you can twist it to obtain correct voltage. Between the black and green wires (i think) you should have 0.98v @ idle with ignition on and engine off, obviously twist the TPS untill voltage is set.
_________________ STREETBUILT RACING |
|||
| Top | |
|||
| kato |
|
||
|
Righto i'll give it a go thanks boys....
_________________ EF XR8 5spd: 302ci /178rwkw |
||
| Top | |
||
| kato |
|
||
|
Ok finally got around to checking tps voltage, was set at 1.4v!! elongated holes and set it up at 0.97v, seems to be fairly normal again, thanks for the help.
Josh
_________________ EF XR8 5spd: 302ci /178rwkw |
||
| Top | |
||
| XH5LWEPN |
|
|||
|
{USERNAME} wrote: Ok finally got around to checking tps voltage, was set at 1.4v!! elongated holes and set it up at 0.97v, seems to be fairly normal again, thanks for the help.
Josh Good stuff mate, easy fix.
_________________ STREETBUILT RACING |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 9 guests |
