Fordmods Logo

Inlet Manifold on Ford EL 98 

 

Page 1 of 1 [ 3 posts ] 

 
 Post subject: Inlet Manifold on Ford EL 98
Posted: Sun May 27, 2012 10:26 pm 
Fordmods Newbie
Offline

Age: 48

Posts: 4

Joined: 27th Jan 2012

Ride: Falcon EL

Location: Adelaide
SA, Australia

Hi Folks 1

Just a quick question, I had to replace the inlet manifold gasket, distributor TFI module (and retime hopefully it's correct lol). I also replaced the fuel rail and injectors with AUIII ones I heard on here it stops some of the surge problems.
Enough babble my problem is which two inlet ports did the EFI harness connector feed up from underneath through the BB inlet manifold (not a fan of this design either) to connect the harnesses.

Thanks for any info I guess if pushed I can work it out on cable length :) or go to the wreckers.

Cheers,
Greg
Top
 Profile  
 
 
 Post subject: Re: Inlet Manifold on Ford EL 98
Posted: Tue May 29, 2012 12:04 am 
Fordmods Newbie
Offline

Age: 48

Posts: 4

Joined: 27th Jan 2012

Ride: Falcon EL

Location: Adelaide
SA, Australia

Looked like the engine loom went through the middle of the inlet manifold.

Last edited by elongas12 on Mon Jun 11, 2012 10:10 pm, edited 1 time in total.

Top
 Profile  
 
 
 Post subject: Re: Inlet Manifold on Ford EL 98
Posted: Sun Jun 10, 2012 8:05 pm 
Fordmods Newbie
Offline

Age: 48

Posts: 4

Joined: 27th Jan 2012

Ride: Falcon EL

Location: Adelaide
SA, Australia

OK just so you guys know I was not a complete whackjob, my second hand EL on gas had been majorly f*(@ed with, there was not bracket for the multipin loom to connect to and someone had
put in completely the wrong oil pressure switch with the wrong connector type can't have been connected for ages..this is an ex-taxi with 760,000k's on it many sins of the past found on this car, it is being brought back to original (still with Tickford gas conversion) sort of condition...

Who knows how to take out the fuel tank to steam clean it as the remnant petrol is so not volatile I think I could flick a match and not much would happen..lol..cheers for any assistance.
Top
 Profile  
 
Display posts from previous:
Sort by  
 Page 1 of 1  [ 3 posts ] 

Who is online

Users browsing this forum: No registered users and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

 

 

It is currently Tue Dec 12, 2017 4:18 pm All times are UTC + 11 hours

 

 

(c)2014 Total Web Solutions Australia - Australian Web Hosting and Domain Names