I have done the climate control install and changed out the original dash/wiring/BEM to high series from Mid and now my power windows wont work and am having problems with airbag code 32.
Previously didn't have a passenger airbag but new dash does and seems there is one extra plug under the steering column that looks like the airbag connector but isn't long enough to reach (has 3 wires instead of 2) and i have plugged in the airbag connector to the column. The old wiring loom/dash doesn't have this extra plug either. I get the same code whether I unplug the airbags, plug them in, or short the plugs out.

Found two wires (both red with white stripe) just been cut off...... one has power other not earth so joined together because old dash has an extra relay behind fuse box. Should I just connect these and leave like that (timeout on power after ignition switched off works fine still). Windows now working properly yay. Also found where the 3 wire plug goes and now is code 52, so will try reset and see how that goes.

All sorted now
Once plugged in and other wires shorted works perfectly!!!