Fordmods Logo

AFPR pressure for 5.0L 


Page 1 of 1 [ 1 post ] 

 Post subject: AFPR pressure for 5.0L
Posted: Sat Nov 14, 2009 8:54 pm 
Stock as a Rock

Age: 52

Posts: 150

Joined: 6th Nov 2009

Ride: AU2 XR8

Location: waroona
WA, Australia

I have just installed a Kirban AFPR, and a speco guage on AU2XR8 with some mods (std 24ld injectors though).

It fired up OK first time, but want to know what the correct pressure is to be. I've heard around 38psi is a good start point. I have mine sitting around 40psi. it runs fine.

What is the effect of lower or higher pressure settings? Iv'e heard higher pressures run a bit rich.

I don't want to get a re-tune at this stage, because I intend to do some mods later on.

Display posts from previous:
Sort by  
 Page 1 of 1  [ 1 post ] 

Who is online

Users browsing this forum: No registered users and 8 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum



It is currently Sat Dec 04, 2021 6:29 pm All times are UTC + 11 hours



(c)2014 Total Web Solutions Australia - Australian Web Hosting and Domain Names