Fordmods Logo

crow cam el xr6 j3 chip 

 

Page 1 of 1 [ 4 posts ] 

 
 Post subject: crow cam el xr6 j3 chip
Posted: Mon Apr 07, 2014 10:23 pm 
Fordmods Newbie
Offline

Age: 30

Posts: 9

Joined: 20th Jan 2014

Ride: falcon xe

Location: melbourne
VIC, Australia

Hey guys just wondering if my el xr6 motor sounds fine to you guys....
i recently fitted a stage 3 crow cam and j3 chip in my el xr6 motor,
it has a new au steel head gasket and new dizzy and tfi module....
i got my cam dialed in last week and still need to dyno tune it..
the car runs well but just wondering if this is normal..

the car sounds better and lumpier then when it was stock and drives ok without the dyno tune...
but like the car runs abit rough up until 3000rpm then it goes good and drives smoothly is this normal?
i was told its because of the bigger cam and running to rich????

so mods it has
stage 3 crow cam
j3 chip
au steel head gasket
pacemakers
standard cat
red back exhaust-cat back...
k and n filter

so im hoping when i get it tuned this thursday my car is gana run a lot smoother and have some good low end power?
Top
 Profile  
 
 
 Post subject: Re: crow cam el xr6 j3 chip
Posted: Mon Apr 07, 2014 10:53 pm 
Moderator
Offline

Posts: 14513

Joined: 7th Nov 2004

Ride: ford falcon au3 xr8

Location: a shit suburb in sydney
NSW, Australia

getting it tuned will help but you have to understand that what you gain up top from a performance cam you generally loose down low. its a bit of a trade off..
Top
 Profile  
 
 
 Post subject: Re: crow cam el xr6 j3 chip
Posted: Mon Apr 07, 2014 11:03 pm 
Fordmods Newbie
Offline

Age: 30

Posts: 9

Joined: 20th Jan 2014

Ride: falcon xe

Location: melbourne
VIC, Australia

oh ok cool thanks man :)
what else small mods can i do ?
should i just change the fuel pump ? replace it with a new one and new o2 sensor?
Top
 Profile  
 
 
 Post subject: Re: crow cam el xr6 j3 chip
Posted: Sun Nov 02, 2014 12:29 am 
Fordmods Newbie
Offline

Age: 26

Posts: 9

Joined: 13th Oct 2014

Ride: El Fairmont

Location: Melburn
VIC, Australia

Where'd you get the work done and how much did it set you back?
Top
 Profile  
 
Display posts from previous:
Sort by  
 Page 1 of 1  [ 4 posts ] 

Who is online

Users browsing this forum: No registered users and 8 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

 

 

It is currently Tue Dec 12, 2017 2:45 am All times are UTC + 11 hours

 

 

(c)2014 Total Web Solutions Australia - Australian Web Hosting and Domain Names