Hi Justfordima,

I already have a prototype working on my EF fairmont turbo. Have a look for my thread in the forced induction section.

I have modified the MS so it has 3 ignition drivers and uses the MS2extra firmware (www.msextra.com). My set up leaves the factory ECU in place to control everything except the engine (Auto, gauges, fans, fuel pump etc).

I just need to sort out a few more details with my car and organise some parts suppliers before I can start producing the kits.

cheers

Daniel.

Very interested in what you have going.

Any idea of possible $$$ and if the transmission being auot would be an issue?

The auto transmission is no problem as the factory ECU is left in place to control it. My EF with the prototype is auto.

Not sure about $$ as I'm still organising suppliers, but I'm aiming for less than $1k for the complete kit.

I have one EF plug and play kit to sell. It comes complete with assembled and modified Megasquirt MS2 ecu, plug in wiring loom, Hose for MAP sensor, Base Tune, CD with tuning software and a tuning cable. It has been tested on my own EF so it's ready to go. The base tune will get you running and driving, but you will need to get it tuned or add a wideband O2 and tune it yourself. If you can bring your car to me, I could also help with tuning at additional cost.

The ECU has a PWM output which can be used for idle control or boost control and also has a spare relay output.

I'm asking $950 for the kit. PM me if your interested.

Regards

Daniel.

 

 

Attachments:

10082008(018).jpg [ 72.48 KiB | Viewed 1234 times ]

10082008(017).jpg [ 86.37 KiB | Viewed 1223 times ]