|
| efxr6wagon |
|
||
|
I am looking at J3 chipping my EF XR6, but want to make sure it is worthwhile. I know there are gains at WOT, but 99% of driving is not at WOT. I am interested especially in part-throttle output and efficiency. If the ECU is operating in closed loop most of the time, and the fuel is determined only by the oxy sensor, without reference to the maps, then chipping should make no difference.
1) When does an EF XR6 operate in closed loop? (eg, throttle position, load, etc) 2) Does closed loop control fuel only? or also ignition timing? Sorry about the basic questions, but I am a newb at ECU programming, so go easy on me  Thanks for your help.
_________________ 95 EF XR6 wagon, 17" FTRs, DBA rotors, KYB/Koni, AU bottom end, ported EF head, backcut valves, SS Inductions, Territory intake, 10.2 CR, Auckland 1258 cam, vernier gear, PH4480 headers, no cat, Tickford 2.5", 2800rpm stall, J3 chip |
||
| Top | |
||
| efxr6wagon |
|
||
|
Anyone have any ideas or can tell where I can read up on this?
Thanx muchly.
_________________ 95 EF XR6 wagon, 17" FTRs, DBA rotors, KYB/Koni, AU bottom end, ported EF head, backcut valves, SS Inductions, Territory intake, 10.2 CR, Auckland 1258 cam, vernier gear, PH4480 headers, no cat, Tickford 2.5", 2800rpm stall, J3 chip |
||
| Top | |
||
| krisisdog |
|
|||
|
Would be best to pm galapogos01 or ask in his J3 thread, Im sure he'd have a very good idea.
|
|||
| Top | |
|||
| efxr6wagon |
|
||
|
Thanks, krisisdog. Will do.
Cheers
_________________ 95 EF XR6 wagon, 17" FTRs, DBA rotors, KYB/Koni, AU bottom end, ported EF head, backcut valves, SS Inductions, Territory intake, 10.2 CR, Auckland 1258 cam, vernier gear, PH4480 headers, no cat, Tickford 2.5", 2800rpm stall, J3 chip |
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: No registered users and 10 guests |
