Fordmods Logo

???? 4 Speed Auto Gear Box Issue ???? 

 

Page 1 of 1 [ 3 posts ] 

 
 Post subject: ???? 4 Speed Auto Gear Box Issue ????
Posted: Sun Mar 23, 2008 2:11 pm 
Fordmods Newbie
Offline

Posts: 7

Joined: 10th Jan 2008

Location: aus
QLD, Australia

Hi Guys.

My Dad has a EF 96 Falcon Auto with only 100,000k's on the clock. Hes had this car since new

The car has never been driven hard.

When you drive the car a little harder then usually for eg, Half throttle but not full. It then will piss out about 250ml of gear box oil from some where. I cant see where its coming from because its sprays the oil everywhere from the driving.


But it wont leak one drop if you drive it easy. no more then 1/4 throttle.

I put back oil in the box and its on full again.

But when it shifts up or down gears then sometimes it will shutter from 2nd 3r 4th or hunt for a gear from 3-4th couple of times. 1st gear is fine.


I have noticed that the gear box oil is very very very dark.

Has anyone else every had a issue with oil pissing out and the box shuttering etc while driving. Mostly does it under load, Eg going up a hill.

Do you think It needs a New Box? or it could be something else? old oil?

Thanks for you help guys
Top
 Profile  
 
 
Posted: Sun Mar 23, 2008 2:21 pm 
Getting Side Ways
Offline
User avatar

Age: 55

Posts: 7031

Joined: 18th Apr 2005

Location: Hobart
TAS, Australia

Trace the two trans oil line that goes into the radiator. check to see if the hoses & clamps are tight. check the contition of the hose as well. also check the side of the radiator for leaks as well.

Take it in for a reverse slush clean{full service}. Midas or ultra tune can do it.

 

_________________

Mind f**k!!! it works on feeble minded ignorant sheeples... there's plenty of em on this site... some are very intelligent but by god they are so thick!!!

Pakrat wrote:
You can buy them seppertly

Top
 Profile  
 
 
Posted: Sun Mar 23, 2008 4:03 pm 
Stock as a Rock
Offline
User avatar

Posts: 190

Joined: 7th Nov 2004

Ride: EF Mont ZL Lane 4x4 Bronco

Location: Widebay
QLD, Australia

hole in torque convertor / loose torque conv bolts?
take off the bellhousing cover and check it out
Top
 Profile  
 
Display posts from previous:
Sort by  
 Page 1 of 1  [ 3 posts ] 

Who is online

Users browsing this forum: No registered users and 71 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

 

 

It is currently Sat Apr 27, 2024 12:58 am All times are UTC + 11 hours

 

 

(c)2014 Total Web Solutions Australia - Australian Web Hosting and Domain Names