hey fellas.

ive recent;y got myself a wade 1512a cam but im unsure how it would run in my car ive been doing some research and have seen these arnt the best for autos?

its got extractors, 3,000 stall with a shift kit, 3,9's

can anyone shed some light if i should install the cam or not

thanks in advance

For a start, you'll need a Moates chip with a tune to get it running properly. Did you do any research on the types of cams available before buying this? The 1521a is designed to work in the upper rev range. You could contact Jason at T.I. Performance (one of the site sponsors) to get a pre-programmed chip. Also, have you installed a XR6 fuel reg?

yea i emailed jason before to make sure i had the right mods to run it without any major issues. i tried to find as much info about the cam as i possibly could and it dose seem like the type of cam i wanna go for, purely because ive got a new engine and box to put in then eventually turbo it down the track..