|
| frankieh |
|
|||
|
Hi guys,
In preparation to getting the EL motor into my EA, I've been moving small stuff over, and today I swapped the EL map sensor in and plugged it into the ED motor.. They are slightly different shapes, and the EL one has a slightly different part number, (but mostly the same). Is there any real difference between the two from a functional perspective? I mean is it going to cause any probs with the ED motor? I'm guessing not, but doesn't hurt to be sure... rgds Franki |
|||
| Top | |
|||
| EBMontTom |
|
||
|
I think for map sensors the part numbers start either with A1A or A2A. As long as the ones your interchanging have the same prefix then should be fine.
_________________ EL XR6 Manual |
||
| Top | |
||
| frankieh |
|
|||
|
cool... I'll have a look later, I think it was the later numbers that differed, the first 5 or so were identical.
seems to be working ok, not that I've noticed any diff to the old one. |
|||
| Top | |
|||
| joolz |
|
|||
|
I know the EA is the same as EL.
|
|||
| Top | |
|||
| TROYMAN |
|
||
|
the part numbers are different due to the time of manufacture.
but are the same. |
||
| Top | |
||
| frankieh |
|
|||
|
ok,
I wouldn't have asked at all, only they are slightly different shapes... The EA one is rectangular and the EL one is angled on one side. I have the EL map and oxy sensors on now.. not noticed any difference so I'm assuming both sets worked fine. |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 99 guests |
