|
| duvauchellemotors |
|
|||
|
Au injectors, are they a good upgrade for a 4l ed that is geting a turbo or should i go for a bigger aftermarket injector, i will be replaceing the fuel pump and presure regulator, i will not be running high boost
|
|||
| Top | |
|||
| bry40l |
|
|||
|
if your replacing the injectors for a turbo set up just go all the way and get proper aftermarket ones
the au 6 cyl ones are only a little better but in a boosted application it would be f**k all difference
_________________ BF XR6 |
|||
| Top | |
|||
| Papa Smurf |
|
||
|
You could use the BA ones. . 0280 158 123 Bosch EV14, 12 ohm, 613 cc @ 3 bar. Total length 79 mm, distance between O-rings 49 mm, long spray end. Jet connector.
The Regulator on the BA Turbo is 4 Bar. http://www.bosch-motorsport.de/pdf/comp ... /EV_14.pdf |
||
| Top | |
||
| jack_mccarthy |
|
||
|
Will the ba injectors fit straight in?
|
||
| Top | |
||
| TROYMAN |
|
||
|
jack_mccarthy wrote: Will the ba injectors fit straight in? they do fit, but are no good on the std engine with std ecu. they will just dump way to much fuel and your engine will struggle to stay running.... |
||
| Top | |
||
| donkey_kong |
|
||
|
Go bigger injectors like 42LB at min its better to be safe then sorry plus you will be future proofing your self
|
||
| Top | |
||
| Lowlane7 |
|
||
|
VS (ecotec) injectors have the same housing as EA-EL. But apparently have a slightly higher flow rate.
Call Aznue Injectors for exact flow rates.. (you can find contact details on the website I'm pretty sure) I messed around with swapping rails, one decked with VS, one with EA. It was too close to call anything, but I reckon with the right tune they may be a good step up.
_________________ [color=#004080]Cheers, Jacob. |
||
| Top | |
||
| orangeshannon |
|
||
|
So with the ba injectors if u upgraded the ecu would they work?
|
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: No registered users and 68 guests |
