|
| efxr6wagon |
|
||
|
If you can't find the factory shims, you can use 10mm OD 316 stainless washers. They are about 0.9mm thick, and cost $5 for a handful. I put them in my EF XR6 two or three years ago when I had the cam reground, and have had no problems. But get the stainless ones, as they are harder than mild steel.
_________________ 95 EF XR6 wagon, 17" FTRs, DBA rotors, KYB/Koni, AU bottom end, ported EF head, backcut valves, SS Inductions, Territory intake, 10.2 CR, Auckland 1258 cam, vernier gear, PH4480 headers, no cat, Tickford 2.5", 2800rpm stall, J3 chip |
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: No registered users and 51 guests |