Fordmods Logo

lots of white smoke compression is fine any ideas 

 

Page 1 of 1 [ 13 posts ] 

 
 Post subject: lots of white smoke compression is fine any ideas
Posted: Thu Jul 04, 2013 2:50 pm 
Oompa Loompa
Offline

Age: 29

Posts: 41

Joined: 30th Dec 2011

Gallery: 4 images

Ride: ea ford falcon/ghia

Location: melbourne
VIC, Australia

Just wondering my car has started to blow alot of white smoke getting worse and worse did a compression Test and all the cylinder are inbetween 150 psi and 175 psi not that much different between all of them there is oil on the spark plugs when I pulled them out any ideas
Top
 Profile  
 
 
 Post subject: Re: lots of white smoke compression is fine any ideas
Posted: Thu Jul 04, 2013 4:11 pm 
Tyre Shredder
Offline
User avatar

Age: 33

Posts: 303

Joined: 5th Oct 2012

Gallery: 3 images

Ride: 99 au ute

Location: Perth
WA, Australia

Pcv valve?

 

_________________

Au series 1 ute. T5 manual, 2.5" redback zorst, Xtreme HD clutch

Top
 Profile  
 
 
 Post subject: Re: lots of white smoke compression is fine any ideas
Posted: Thu Jul 04, 2013 4:32 pm 
Oompa Loompa
Offline

Age: 29

Posts: 41

Joined: 30th Dec 2011

Gallery: 4 images

Ride: ea ford falcon/ghia

Location: melbourne
VIC, Australia

I bought a new one like a year ago what are ways to see if it's not working?
Top
 Profile  
 
 
 Post subject: Re: lots of white smoke compression is fine any ideas
Posted: Thu Jul 04, 2013 7:12 pm 
Tyre Shredder
Offline
User avatar

Age: 33

Posts: 303

Joined: 5th Oct 2012

Gallery: 3 images

Ride: 99 au ute

Location: Perth
WA, Australia

I'm pretty sure you take it off and blow/suck on it, it's basically like a check valve. When I had a vl it done something similar. About a week if doing it, it lost compression in one cylinder and blew the rear main seal. A pcv valve won't do that though

 

_________________

Au series 1 ute. T5 manual, 2.5" redback zorst, Xtreme HD clutch

Top
 Profile  
 
 
 Post subject: Re: lots of white smoke compression is fine any ideas
Posted: Fri Jul 05, 2013 3:25 pm 
Oompa Loompa
Offline

Age: 29

Posts: 41

Joined: 30th Dec 2011

Gallery: 4 images

Ride: ea ford falcon/ghia

Location: melbourne
VIC, Australia

Ok so I checked everything cleaned spark plugs and what not put spark plugs back in everything back on and now Car is really hard to start when cold it like just starts and sometimes doesn't of cranking it over and Over again then once it does get started it runs perfect no smoke now eithe. Only a little bit cause it floods itself I'm guessing I have replaced map sensor oxy sensor and ecu and nothing has changed
Top
 Profile  
 
 
 Post subject: Re: lots of white smoke compression is fine any ideas
Posted: Sat Jul 06, 2013 10:22 am 
Getting Side Ways
Offline
User avatar

Age: 56

Posts: 6467

Joined: 18th Dec 2006

Ride: 93 ED sedan

Power: 161 rwkw

Location: Rockhampton
QLD, Australia

What engine oil are you using in it ?????

 

_________________

http://youtu.be/jJTh9F3Vgg0

Top
 Profile  
 
 
 Post subject: Re: lots of white smoke compression is fine any ideas
Posted: Sat Jul 06, 2013 12:28 pm 
Oompa Loompa
Offline

Age: 29

Posts: 41

Joined: 30th Dec 2011

Gallery: 4 images

Ride: ea ford falcon/ghia

Location: melbourne
VIC, Australia

I went up to 20-50 cause 15-40 I could smell the oil burning bad
Top
 Profile  
 
 
 Post subject: Re: lots of white smoke compression is fine any ideas
Posted: Sun Jul 07, 2013 10:52 am 
Getting Side Ways
Offline
User avatar

Age: 56

Posts: 6467

Joined: 18th Dec 2006

Ride: 93 ED sedan

Power: 161 rwkw

Location: Rockhampton
QLD, Australia

Valve stem seals ???

 

_________________

http://youtu.be/jJTh9F3Vgg0

Top
 Profile  
 
 
 Post subject: Re: lots of white smoke compression is fine any ideas
Posted: Sun Jul 07, 2013 4:04 pm 
Oompa Loompa
Offline

Age: 29

Posts: 41

Joined: 30th Dec 2011

Gallery: 4 images

Ride: ea ford falcon/ghia

Location: melbourne
VIC, Australia

I was thinking that would that eventually make it hard for my car to start in the cold??
Top
 Profile  
 
 
 Post subject: Re: lots of white smoke compression is fine any ideas
Posted: Sun Jul 07, 2013 5:52 pm 
Getting Side Ways
Offline
User avatar

Age: 56

Posts: 6467

Joined: 18th Dec 2006

Ride: 93 ED sedan

Power: 161 rwkw

Location: Rockhampton
QLD, Australia

nathaneaford wrote:
I was thinking that would that eventually make it hard for my car to start in the cold??


Not really....only if the plugs are really oiled up.
Is the ignition timing right ????

 

_________________

http://youtu.be/jJTh9F3Vgg0

Top
 Profile  
 
 
 Post subject: Re: lots of white smoke compression is fine any ideas
Posted: Sun Jul 07, 2013 9:18 pm 
Oompa Loompa
Offline

Age: 29

Posts: 41

Joined: 30th Dec 2011

Gallery: 4 images

Ride: ea ford falcon/ghia

Location: melbourne
VIC, Australia

Yes it was perfect but would a faulty tfi module do it? Cause it gets fuel as I can smell it I have changed just about everything now besides the coil and dissy there is spark though I just checked with a screw driver
Top
 Profile  
 
 
 Post subject: Re: lots of white smoke compression is fine any ideas
Posted: Sun Jul 07, 2013 9:46 pm 
Getting Side Ways
Offline
User avatar

Age: 56

Posts: 6467

Joined: 18th Dec 2006

Ride: 93 ED sedan

Power: 161 rwkw

Location: Rockhampton
QLD, Australia

Vacuum leaks ????....intake gasket ???

 

_________________

http://youtu.be/jJTh9F3Vgg0

Top
 Profile  
 
 
 Post subject: Re: lots of white smoke compression is fine any ideas
Posted: Sun Jul 07, 2013 10:23 pm 
Oompa Loompa
Offline

Age: 29

Posts: 41

Joined: 30th Dec 2011

Gallery: 4 images

Ride: ea ford falcon/ghia

Location: melbourne
VIC, Australia

We'll tomoz I am going to be removing all the intake manifold and everything and see if it works
Top
 Profile  
 
Display posts from previous:
Sort by  
 Page 1 of 1  [ 13 posts ] 

Who is online

Users browsing this forum: Google Adsense [Bot] and 78 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

 

 

It is currently Fri Apr 26, 2024 6:26 pm All times are UTC + 11 hours

 

 

(c)2014 Total Web Solutions Australia - Australian Web Hosting and Domain Names