|
| Mad2 |
|
|||
|
panmahi wrote: Thanks SWC. It is not working mate. I suspect the AC compressor. Does anybody know how to check the AC compressor and clutch ? Cheers,panmahi AC compressor/clutch won't stop car from starting .... do as grumps said & thump dash above handbrake. |
|||
| Top | |
|||
| panmahi |
|
||
|
Thanks Mad2.
I thought BCM is on the dash board near steering. I hit there. Could you please tell me exact place where I need to bang ? Cheers, panmahi |
||
| Top | |
||
| Mad2 |
|
|||
|
don't know the exact spot .... none of mine have this problem lol
 somewhere to the left of the instrument cluster i think? |
|||
| Top | |
|||
| panmahi |
|
||
|
Hi Guys,
I found the location on BCM. I hit on the dash board on left side of the steering, down near the left knee level. But still no luck. Still engine is same. I found a new observation on the dash board. When the start effort is made and engine is cranking, two warning lights come on the dash. They are, 1. Smart lock flashes. 2. Braking system failure appears (just below the park brake on light) They disappears when the key is back on "on" position. I hope you guys have some idea the meaning of these warning. Cheers, panmahi |
||
| Top | |
||
| Mad2 |
|
|||
|
try this from factory manual ... dunno if it will help ya or not
|
|||
| Top | |
|||
| SWC |
|
||
|
If Smartlock light flashes while trying to start, you have BCM issues (Smartlock).
|
||
| Top | |
||
| panmahi |
|
||
|
Thanks SWC.
What should I do for the BCM issue ? Do I have to replace the BCM ? Cheers, panmahi |
||
| Top | |
||
| panmahi |
|
||
|
Hi Mad2,
Where can I find this factory manual ? Cheers, panmahi |
||
| Top | |
||
| Mad2 |
|
|||
|
there are some on ebay .... but a little $$$
|
|||
| Top | |
|||
| SWC |
|
||
|
|||
| Top | |
||
| Mad2 |
|
|||
|
dunno why i keep thinkin its a EA/EB/ED ???
|
|||
| Top | |
|||
| panmahi |
|
||
|
Thanks guys. I have the repair manual, 420 pages. But it doesn't contain the diagnostic chart Mad2 given.
The update of the problem : The smart light indication was eliminated. The 30A Eng fuse had gone during my work. I don't know how it is gone. Smart lock light is gone after replace the fuse. But still not starting. The AC clutch found engaged when the key is on, even before the start. But I think it would not be a problem to start the engine. Cheers, panmahi |
||
| Top | |
||
| Mad2 |
|
|||
|
maybe try leaving ignition on reds for 1/2hr [think thats it? ] and then see what happens
can someone confirm time frame please any other fuses blown? |
|||
| Top | |
|||
| SWC |
|
||
|
Wind down the Drivers window.
Turn all accesories off ie: radio. Close the door and turn the ignition to "Reds". Wait for 30 to 60min. Door locks will cycle. Turn ignition off. Start the car. |
||
| Top | |
||
| panmahi |
|
||
|
Thanks SWC.
That test also done. I was not waiting near the Car. Left more than 1 hr and then off and started again. Not working. No response. I checked again ECU for error codes. No errors. Cheers, panmahi |
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: No registered users and 73 guests |
