Fordmods Logo

stainless intake pipe.....worth doing? 


Page 3 of 3 [ 32 posts ] Go to page Previous  1, 2, 3

Posted: Wed Jan 31, 2007 12:52 pm 
Getting Side Ways
User avatar

Age: 33

Posts: 1442

Joined: 26th Apr 2006

Gallery: 6 images

Ride: 97 EL XR6

Power: 162 rwkw

Location: liverpool
NSW, Australia

why do you have a rubber boot going to the airbox? Also the the two pieces of pipe are off centre and would be disrupting any possible airflow gains.

that rubber boot you talk about is the same as the standard bend in the standard setup, its there because i done away with that adaptor plate on the back of the air box as it opens it up from about 58mm to 75mm, the main restriction in the intake! so why keep the adaptor unless you want to cut the guts out of it. and the other reason i went with that was so i could mount the pod easily inside of the box, its strong enough to carry the weight of the pod.

the 2 pipes almost but up against eachother inside of the bend so it not like the air has to travel far before its gets into the next pipe. i dont think its a problem at all...



310rwkw @ 13psi - Tuned By CMS

Posted: Wed Jan 31, 2007 1:05 pm 
Smokin em up

Age: 33

Posts: 288

Joined: 12th Nov 2004

Ride: fairmont ghia

Location: perth
WA, Australia

if you got it ceramic coated will this help with the heat soak????
Display posts from previous:
Sort by  
 Page 3 of 3  [ 32 posts ]  Go to page Previous  1, 2, 3

Who is online

Users browsing this forum: No registered users and 16 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum



It is currently Fri May 25, 2018 7:18 am All times are UTC + 11 hours



(c)2014 Total Web Solutions Australia - Australian Web Hosting and Domain Names