|
| lowie57 |
|
|||
|
hey guys, trying to resolve my running ritch issue, got a spare complete BBM im going to swap over, and possibly replacing the heater hose, trying to think of things i can replace or fix up while the BBM is off,.. things i plan on doing are..
Swap BBM, Look at fixing/replacing heater pipe, Swap Dizzies, New ignition leads and plugs, New map sensor, New Oxygen Sensor, New panel filter.. If anyone can think of thing else i can do while doing these id love to hear your suggestions |
|||
| Top | |
|||
| mystro |
|
||
|
check and clean coolant temp sensor,check iat,check vac hoses,map sensor,tps, if those havent been mentioned
|
||
| Top | |
||
| mystro |
|
||
|
also make sure you pull our battery before you do it.
im guessing you have already done a diagnostic ? |
||
| Top | |
||
| lowie57 |
|
|||
|
which hoses are vac hoses? and how do you suggest i go about checking them (other than visually)? and what is a iat?
|
|||
| Top | |
|||
| mystro |
|
||
|
lowie57 wrote: which hoses are vac hoses? and how do you suggest i go about checking them (other than visually)? and what is a iat? i blow in mine lol in a bucket of water, one goes from back of bbm to the map sensor on the firewall the other is a f piece for the pcv valve the rear of rocker cover and charcoal canister. the intake air tempreture sensor is next to said f piece |
||
| Top | |
||
| mystro |
|
||
|
theres more vac lines at the back that go to the fuel pressure reg ,the brake booster and the bbm actuator, heater tap and aircon afaik
|
||
| Top | |
||
| lowie57 |
|
|||
|
is the coolant temp sensor your speaking of the one that people like to change to the 80ish degree instead of 90ish?
|
|||
| Top | |
|||
| snap0964 |
|
|||
|
Nah, that's the thermostat.
Take out the oil pressure switch/sender, and clean the oil gallery in the switch with metho and a soft brush.
_________________ 96 XH Longreach 'S': LPG, Alarm, 3.23:1 LSD, Cruise, Trip Comp, ABS, Power Windows, Mid Series Dome Lt, Climate Ctrl |
|||
| Top | |
|||
| lowie57 |
|
|||
|
also, after getting an engine swap done, my exhaust seemed to rattle really bad at low revs, it didnt happen all the time, i usually noticed it more when it was running worse than usual, could this potentially be adding to my problem?
|
|||
| Top | |
|||
| TROYMAN |
|
||
|
lowie57 wrote: also, after getting an engine swap done, my exhaust seemed to rattle really bad at low revs, it didnt happen all the time, i usually noticed it more when it was running worse than usual, could this potentially be adding to my problem? sounds like you cat has collapsed???? |
||
| Top | |
||
| lowie57 |
|
|||
|
would that explain it running ritch/ blowing black smoke?
|
|||
| Top | |
|||
| elrob |
|
||
|
this may sound strange but my au was running rich (200 kms to a tank around town) replaced all sensors and didnt fix.replaced fuel pump and it now gets 400+kms from a tank
|
||
| Top | |
||
| TassieTiger |
|
||
|
a stuffed Cat will blow black im sure.,mine did and run like a pig and dont wanna go anywhere (had to force it to drive )at low and certain revs was a bastard when i didnt have resorces at time to fix it was in my old eb i drove round Aus drove for 100s of k's to get to port augusta to get it fixed lol 180 from the wreckers it cost me
 ran sweet a** then went back to uluru and BAm that was the end of that old girl  had a head on with two cows at Marla )even just take the Cat off and check ( take off n give a shake )while BBM is off as car aint movin till its back on
_________________ Lowndes,wincup & courtney ..Number 1 Tr888tors.....bring Ambrose back |
||
| Top | |
||
| lowie57 |
|
|||
|
Im having trouble taking the BBM off, ive taken the airbox out, i have undone all the bolts that hold the BBM onto the head, ive unplugged most of the wiring loom, i cant get to the plugs undearneath the BBM yet, also there is what im guessing an earth wire connected to the bolt on the block thats holding the BBM support brace behind the A/C.. how do i undo that bolt without taking off the A/C?
And im having trouble getting the hoses off the fuel rail and fuel regulator. There is also a big square plug between injectors 5 and 6 that almost made it impossible to get behind, i ended up just pulling the fuel rail off to move the plug out of the way.. but i dont want to remove the fuel rail on the new BBM to get the plug back inbetween there? Any suggestions would be greatly appreciated. |
|||
| Top | |
|||
| TassieTiger |
|
||
|
well theres 2 brackets bolted to the BBM one at front side of BBM one in rear near fuel lines ..i left fuel hoses on and cut the lines down under the chassie n re joined with alloy fuel line and clamps. i split my BBM in half so i could see all wires n plugs a bit better .theres wires near AC one grey i think and one circle plug also to coil pack etc and also circle plug onto the BBM near plastic hose fitting from rocket cover, dont forget them plugs as there easy to rip out if u forget to get them n just try pullin it off i replaced mine never had to touch A/C
_________________ Lowndes,wincup & courtney ..Number 1 Tr888tors.....bring Ambrose back |
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: No registered users and 65 guests |
