yep.. but i read and understood to what u have said.. making ur opinion stick to me. and other people who have read this.. so thanks.

Cant say I noticed any improvements, mainly did it to make sure future mods had sufficient air flow. The adaptor is made out of a piece of 3mm plate and some 75mm exhaust pipe. The pipe had a V cut out of it, (not all the way through, left enough to keep as one piece) then the V closed up and welded. The plate was cut to a cardboard template I took off the air box lid. A bit of stuffing around but it kept me out of trouble for a few hours. Hope the working drawings help.

 

 

Attachments:

File comment: Pod adaptor drawings DSC03335.JPG [ 76.61 KiB | Viewed 110 times ]

Same here.. better air intake.. for future mods...also its what u start off first.. the air intake.

Close or delete this forum. thanks.

forums are never deleted, unless racial or religious arguments are started

use a 3 inch pipe running into the airbox and use a shortened 45 degree silicon joiner onto that with a short 3 inch steel cutoff on the other end to give the pod filter something to clamp onto. Perfect fit.