I think that is an excellent idea!

I think such a document would be a hit!

By the looks of those terminals, they are not crimp terminals. They are simply a solder job, easiest way, strip & Twist wire a little, make sure it will slide easily in& out of the terminal. Then put the terminal in a vice (The ring part that is) to hold it steady, grab your soldering iron & some Good solder, and slowly melt it into the terminal , while maintaining heat to the terminal side (And therefore the solder) while its still melted, slowly push the wire into the terminal, you will have some overflow, but that cleans up easy enough. Let cool, check for good solid hold & Job done.


This is of course assuming they do not have a hole at the other end where i cannot see, if they do, then yeah, tint the wire, put it in, bit of solder, belt the crap out of the terminal to crimp, touch up a bit more solder, job done.