|
| Reggie D |
|
||
|
The drivers side door has closed and wont open. This is after i have put a new hndle on the outside. Is this because I didnt put the "clasp" Low enough on the lock rod? Is there any tricks to opening the door? Any help appreciated!
|
||
| Top | |
||
| frd906n |
|
||
|
Wrong section
_________________ Daily Driver, Series 1 Au Forte Quote: Posted by Xcabbi, Does it slap or rattle? Rattle is more to do with timing chains and tensioners. Slap is more to do with lifters, rings, bearings or GENIII boat anchors
|
||
| Top | |
||
| Reggie D |
|
||
|
What section then mate? sorry am new
|
||
| Top | |
||
| ef_falcon_95 |
|
|||
|
'6 cylinder workshop' i reckon
_________________ El XR6 Turbo |
|||
| Top | |
|||
| TerroristGHIA |
|
|||
|
Welcome to fordmods.
If you can open the door from inside, then do so. Remove the door card then close the door and look at the way the handle behaves when opening the door. This will tell you where and how high up to attach the rod. Is it a front or rear door, as the safety lock may be on on the rear and then you have some problems. Always when playing with handles either inside or outside leave the door card off and check functionality before final reassembly. This thread should also be in the exterior mods section. Cheers and goodluck Brett
_________________ The Terrorist ED Retired due to RUST. |
|||
| Top | |
|||
| fairlane6970 |
|
|||
|
ef_falcon_95 wrote: '6 cylinder workshop' i reckon But my V8 has doors too!  
_________________
|
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 24 guests |
