Ok the deal is at work we have a bonnet that we have made for what i presume to be a ba/bf and instead of the famous ba bump it has a custom made higher and sportier looking hump and i have decided to make a copy of this hump and then ill chuck it on the steel bonnet make a mould out of the steelie and then make myself a carbon bonnet i will take a photo of the bonnet we have made tomorrow at work but for now this is what it looks like in paint drawings


The yellow is nothing, the hump will sit square in the middle of the bonnet and has a steep acent and a steady decent the purple bits are custom made air vents about six or seven inches long the pink is pretty much where it angles off to the side the middle pic is a side on and the last is a front on, after i suceed i may think about making a mould specific for the hump and make carbon of fiberglass copys for fairly cheap.

So what do you think of my plan?

 

 

Attachments:

File comment: my crappy drawing Hump.PNG [ 23.8 KiB | Viewed 125 times ]

do you have photoshop?, maybe do somthing with that to give a better picture on what you want to do.

na i don't have photoshop but i will take a photo of the bonnet tomorrow after i start work on the mould it should give better description.

are you in pre skool nice drawig... lol sounds like it would be unreal

Well this is the bonnet dont mind the dust on it i work in a very dusty factory, what do you reckon?(by the way this isnt my bonnet i am just making the hump.) and i was a bit out with the crappy drawing.

interesting. will be good to see how this turns out.

I would like it in a Ef futura it would look great.