|
| billpatt@tpg.com.au |
|
||
|
The front bumper on my XR6 needs to be raised about 1cm as the gap between the bumper and side guards are uneven and diverge towards the front. I suspect that this adjustment is very straight forward but i have been unable to find where to adjust the bumper.
If anyone would be able to provide assistance it would be greatly appreciated. Regards BillP |
||
| Top | |
||
| psupernak |
|
||
|
best way is to remove the number plate, sit the bar upwards and put two long self tappers in the holes where ford should have put bolts
_________________ aaahh yes! a forums with more freedom than a nerd in an empty library- www.psupernak.com register asap! |
||
| Top | |
||
| GlennBA |
|
|||
|
if its a bf it should be under warranty. take it back to ford
|
|||
| Top | |
|||
| psupernak |
|
||
|
i work at ford and thats what they'd do, unfortunately thats the only fix
_________________ aaahh yes! a forums with more freedom than a nerd in an empty library- www.psupernak.com register asap! |
||
| Top | |
||
| billpatt@tpg.com.au |
|
||
|
|
||
| Top | |
||
| Black Betty |
|
||
|
Remove the front bar and then remove the plastic absorbers and re drill them slightly higher as this is what the bar rests on at the front or put some foam tape along the top edge of the absorber.
|
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: No registered users and 21 guests |
