|
| ELFAIRY |
|
||
|
had my rear ghia badge nicked off my boot....bought a new one i found on ebay but its dead flat and it has to go on the curve of the boot?? am i supposed to try and bend it on or is there one specific for the boot?? thanks
_________________ Live, Play, Work - FORD |
||
| Top | |
||
| jet ute |
|
||
|
Yeah they just bend so start in one corner and push it down to the next side my mate done it and it works
_________________ Super Pursuit |
||
| Top | |
||
| ELFAIRY |
|
||
|
ahh ok thanks.....just it was pretty thick and stiff so i thought id ask before i snapped it or something
_________________ Live, Play, Work - FORD |
||
| Top | |
||
| synaps |
|
|||
|
You could try using a hairdryer to soften the plastic first, then bending it to fit the curve
_________________ I made a signature but I ated it. |
|||
| Top | |
|||
| bbot |
|
||
|
tell me if you end up fitting it proply
|
||
| Top | |
||
| ELFAIRY |
|
||
|
yea pushed it on hard on the flattter bit of the curve of the body and pushed for about 2 minutes.....on there fine....yea i thought about the hair dryer but couldnt be bothered haha....cheers
_________________ Live, Play, Work - FORD |
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: No registered users and 30 guests |
