Fordmods Logo

BA front speakers 

 

Page 1 of 1 [ 4 posts ] 

 
 Post subject: BA front speakers
Posted: Sat Oct 02, 2010 6:12 pm 
Fordmods Newbie
Offline

Age: 33

Posts: 4

Joined: 11th Nov 2004

Ride: EA-machine!!!

Location: ask me
NSW, Australia

Firstly, sorry is this is a repost

Any help on the matter would be so greatly appreciated.

I would like to run speaker wires from the amp in the boot to the front speakers, as the factory setup is substandard.

Is there a guide, wiring diagram, kick panel removal diagram? that exists or anyones personal experience on the matter?

I just cant seem to run a wire through the door through into the cabin, its almost nearly impossible.

PLEASSSSSSSSSSSSSSSEEEEEEEE help its driving me mad (no pun intended).

cheers.

 

_________________

EA 3.9 multipoint- bosch super four spark plugs and leads. KnN air filter, heavily customised air intake, 2.5 inch exhaust + whistle. absolute commowhore eater.

Top
 Profile  
 
 
 Post subject: Re: BA front speakers
Posted: Sun Oct 03, 2010 12:17 am 
Getting Side Ways
Offline

Age: 37

Posts: 1273

Joined: 30th Sep 2007

Ride: g6e 2009

Location: hiding in the bushes
WA, Australia

mate to run a wire through from the door into the cabin, run it alongside the door loom wires and through the rubber boot into the cabin. simply push a coathanger through the boot alongside the plugs and pull your wires through. then do the same from the cabin floor to where the plug connects to the one in the cabin. you could even fit a small 2 pin plug in there if your worried about disconnecting it later. then run in the usual fashion under the door sills.
Top
 Profile  
 
 
 Post subject: Re: BA front speakers
Posted: Sun Oct 03, 2010 10:36 pm 
ACT Cruise Moderator
Offline
User avatar

Age: 36

Posts: 6275

Joined: 24th Nov 2004

Ride: '06 BF GT-P

Power: 293 rwkw

Location: Canberra
ACT, Australia

It is possible, but VERY difficult.

Been there, done that. Not doing it again. (ran two sets into each door, as I've got two speakers in each door)

phatba has the process about right. It's just f**k difficult to do.

 

_________________

1998 DL LTD in Sparkling Burgundy, daily, 302W, stereo, slow - 97.5rwkw
2006 BF GT-P in Ego, mods. 293rwkw - 12.427@109 - 0-1000m 24.838@221

Top
 Profile  
 
 
 Post subject: Re: BA front speakers
Posted: Sun Oct 03, 2010 10:43 pm 
Getting Side Ways
Offline

Age: 37

Posts: 1273

Joined: 30th Sep 2007

Ride: g6e 2009

Location: hiding in the bushes
WA, Australia

i didnt find it that difficult. i simply pulled the door loom out and threaded the wires through the boot and put a 2 pin plug at the end. using a coat hanger i pulled 2 more wires with the other end of the plug into the cabin from the spot where the door loom comes in. re-install the door loom and plug together your wires. then do your new door speaker wiring and trim the length to suit, and then run your wires inside the cabin as needed. i did that to run the fairmont ghia door courtesy lights on an xt when i did a 4 way power window conversion and fairmont ghia interior swap at the same time.
Top
 Profile  
 
Display posts from previous:
Sort by  
 Page 1 of 1  [ 4 posts ] 

Who is online

Users browsing this forum: No registered users and 19 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

 

 

It is currently Sun Dec 17, 2017 11:13 am All times are UTC + 11 hours

 

 

(c)2014 Total Web Solutions Australia - Australian Web Hosting and Domain Names