|
| JOSE |
|
|||
|
Well a while back mine got real tight to move, which i knew wasnt a good sign, now it seems to be broken, it still moves up and down but has no effect on where the air comes from (its stays on screen/feet) im assuming the cable that comes out the back and off to the passenger side of the car is the one that this lever actuates, and i suspect that there is a crappy plastic arm that controlls the blend door which is broken, do i have any chance of fixing this WITHOUT removing my dashboard?
_________________ Because i can. |
|||
| Top | |
|||
| philaddis |
|
|||
|
This is confusing. By the sound of it you are talking about the vent control on a standard A/C (low series) rather than the blend door on a climate control (high series) system.
The blend door is actually in the heater box and blends cold air with hot air to control the temperature. Is this what you are talking about? If as I suspect you are talking about the vent control I would say your actuator has seized and it is no longer moving the vacumn control that controls your vent vacumn. (Try saying that five time fast) Check it out by removing your glovebox and trim near the golvebox. Get someone to move the control whilst you look at the air box itself. See what happens.......
_________________ ED XR8 Spri-mitatio-nt |
|||
| Top | |
|||
| JOSE |
|
|||
|
vent controll - blend door, i knew which bit i was talking about
 , but yeh, it sis the vent contoll i was talking about, will pull my glovebox out tommorow and have a look
Thanks
_________________ Because i can. |
|||
| Top | |
|||
| Ace |
|
||
|
Mine went in the EL, $750 to get replaced @ ford ...
fkn ripoff 
|
||
| Top | |
||
| JOSE |
|
|||
|
this will be a fencing wire and ductape fix,
_________________ Because i can. |
|||
| Top | |
|||
| philaddis |
|
|||
|
$750 from ford is a ripoff!!!
I got a complete ghia dash, airbox, loom and body loom for $100 from a wrecker and it works a treat!!! Gold Jerry...GOLD!
_________________ ED XR8 Spri-mitatio-nt |
|||
| Top | |
|||
| JOSE |
|
|||
|
Just fixed it, guess how much it set me back????
$0 it turns out the vacume line from the manifold had come loose (i discovered this AFTER i pulled my dash apart). I bet it had something to do with my stupid car surging too.
_________________ Because i can. |
|||
| Top | |
|||
| sheppy |
|
||
|
Mine's doing it too... where's that line located on the manifold?
|
||
| Top | |
||
| JOSE |
|
|||
|
passenger side of engine bay, youll see a green/blue coloured one first leading from high up on the firewall to below the intake manifold, near it is a black one, it should plug into the extension on the back of the intake manifold.
if you have any probs finding it i can put up a pic of what im talking about.
_________________ Because i can. |
|||
| Top | |
|||
| sheppy |
|
||
|
I found it, and it was firmly connected
Anything else I could try?
|
||
| Top | |
||
| JOSE |
|
|||
|
Ok so NEITHER your vent controll lever or blend door controlls are working?, might be a blocked vac line, or the switch is stuffed, im not really sure.
_________________ Because i can. |
|||
| Top | |
|||
| sheppy |
|
||
|
I've pulled apart the dash and the switch looks to be in working order. Any way I could check the vac line?
|
||
| Top | |
||
| JOSE |
|
|||
|
not any that i KNOW will work
_________________ Because i can. |
|||
| Top | |
|||
| Andrew J |
|
|||
|
start the car, remove the line, and put your finger on it! If it sucks, its got vacuum. The door that controls the fresh/recirc air select has a flimsy little plastic piece that uses vacuum to shift it. if yours is stuck on fresh constantly, then this might be stuffed. Big job to fix properly, but doable. Gotta pull the whole left side of the dash out, and then the box itself so that you can fix it. other people have just screwed it in the recirc position though
_________________ The problem with America is stupidity. I'm not saying there should be a capital punishment for stupidity, but why don't we just take the safety labels off of everything and let the problem solve itself?
|
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 30 guests |
