|
| BOSXR8 |
|
|||
|
im sure alot have done this (a green wagon comes to mind). the back seats are a straight swap correct? and with the front ones, are the two front bolts the same? i know that there needs to be a divider or something for the rear ones. i think its only the one bolt at the back closest to the centre console that needs modifying, and the outter one bolts straight on too is that correct? any help/info/ anything would be much appreciated
anyone want ebII gli seats in sydney? pm me!
_________________ EB SXR6. ED XR8 Sprint. |
|||
| Top | |
|||
| TS50EB |
|
|||
|
The front nearest the centre console and the rear furthest from the centre console are the same EB to EF. To fit the EF bolts that are out of alignment there are 2 ways to do this,
1. drill the front hole thru the floor, and put a longer bolt thru the rear or 2. get the pieces EF floor pieces cut into your floor.
_________________ The car should be called "Frankenstien". EBII GLi skeleton, AU T2 220kw heart, AU2 brain, EF/EL for everything else. |
|||
| Top | |
|||
| mongrelEB |
|
||
|
Or, use a bit of pipe to extend the rear inner corner mount on each front seat. Then drill ya hole and stick a bolt through the lot. Crude but effective
_________________ 1xEB with full EF Ghia interior and AU motor
|
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: No registered users and 4 guests |
