|
| fordnut1988 |
|
||
|
hi all i want to increase the light of the foot well lighting on the passenger side under the glove box in my ef fairmont has anyone modified this light? if so how did you about it and also pics please???
|
||
| Top | |
||
| revcore |
|
|||
|
Could always try a LED globe or even wire in an extra light. I plan in wiring in an extra light on both the drivers and passenger footwells.
_________________
|
|||
| Top | |
|||
| Gab1 |
|
|||
|
I'd be interested in other people's thoughts on this too. A mate of mine used the parker globes that came with a set of Phillips "Crystal Vision" headlight globes and they worked pretty well.
Gab |
|||
| Top | |
|||
| FordFairmont |
|
||
Posts: 6113 Joined: 8th May 2007 |
cut the plug and join the pos & neg wires to a SMD/LED strip
http://www.ebay.com.au/itm/30cm-5050-SM ... 0573072717? 
|
||
| Top | |
||
| TimmyA |
|
|||
|
This is mine... As much as I would love to re-write it all... I'm just going to link my build thred page instead as I'm in a slightly lazy mood...  the-garage-f53/re-timmya-s-93-ed-falcon-new-mags-are-on-t79040-195.html Not sure if I mentioned it in there... But the drivers side is cable tied to the upp steering column (part that doesn't turn)... And Passengers side, I pulled the glove box out... Drilled a few small holes in the plastic that runs between the two hinges for the glove box on the bottom of the dash and cable ties the light to there... Cheers, Tim
_________________ 93 Red ED 5spd Manual Build Thread |
|||
| Top | |
|||
| AU99 |
|
|||
|
I was at a local wreckers and spied an AU Lane and a AU Fairmont....
Couple snips later and tada they were mine I used these cool 12smd LED T10's I found on ebay along with a 12smd Panel led for the roof light. Wow its bright!! http://www.ebay.com.au/itm/2-x-White-12 ... 2a16c2639c http://www.ebay.com.au/itm/4x-White-T10 ... 2a16ff195e
_________________ 2003 BA Falcon Egas Taxi Pack - XR Replica |
|||
| Top | |
|||
| fordnut1988 |
|
||
|
ive put a t10 blue led (t10 is also whats used in parkers) in and it works quite well
|
||
| Top | |
||
| teeroy |
|
|||
|
yeah go the SMD LED's, i spliced mine from the footwell light and kept them going too, nice bright larger coverage, only problem is a little lip, nothing decent pliers won't snip off and help broaden the lightspread.
plus for a few bucks off ebay, can't go wrong.
_________________ be good or be good at it. |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 24 guests |
