hi, have recently installed this unit and are having problems with configuration and activation


unit is fully connected as per factory specifications

on initialising CPU (by turning ignition on) dash display flashes lights as per expectations showing preparing to starton petrol before switching to lpg and tank level indication is also correct,then after about ~ 10 seconds all lights on display go out?? i am assuming CPU is depowering down and hibernating again??

can access CPU via interface and laptop and CPU is reading lamba signal and sometimes also gas temp and pressure but revs are out by a huge factor of 1000 ie 800 RPM is 800,000?


cannot run auto calibrate due to not having dongle

any ideas please

rob