|
| CPOCSM |
|
|||
|
Gday all - just a quick one this time...
Who knows the diameter of the water hoses going in and out of the throttle body assembly on a EB XR8? I was poking about last night and located the leak which caused the demise of my starter motor. It had a pinhole leak which was dripping ever so slowly onto the manifold below and then ultimately onto the starter. Any help would be fab... Yours, Aye RF |
|||
| Top | |
|||
| XR9UTE |
|
||
|
1/4"
|
||
| Top | |
||
| CPOCSM |
|
|||
|
Big thanks XR - didntwant to pull it before I knew what it was. I have to work out now how to get my mits down into the back of the manifold to remove it(SVI plumbing).
Good week-end job for me(that and getting the 1977 mini motor back in the shell) Hooroo |
|||
| Top | |
|||
| XR9UTE |
|
||
|
No wuckers, btw it's actually EGR plate cooling.
|
||
| Top | |
||
| CPOCSM |
|
|||
|
XR9UTE wrote: No wuckers, btw it's actually EGR plate cooling. Trust me it is heating when you live in Canberra!! Thanks for the correction and I am off to buy a metre of 1/4 inch heater hose from clark rubber. Hooroo |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 28 guests |
