|
| TIAMO |
|
|||
|
Thats cool got 2lt of Castrol SAF-XA for my XR8 sitting there, use that. Do a bit of a flush now...
|
|||
| Top | |
|||
| TimmyA |
|
|||
|
if they are only small shavings I doubt you'll have much of an issue... They wont cause any hassle... Its more where they have come from thats the worry...
_________________ {DESCRIPTION} |
|||
| Top | |
|||
| SlySlayer |
|
||
|
Hey mate I am just wondering if you still have those pics of the axle and whatever else relating to doing the bearing on the read end would be much appreciated.
|
||
| Top | |
||
| TimmyA |
|
|||
|
Hey mate,
This axle is slightly bent... {DESCRIPTION} You can see the flange plate, seal is behind that, bearing behind that and lastly the retainer... The retainer will not press off... It will need to be split with a cold chisel (bearing kit should included a new one)... Bearing will press off... Polish where the seal runs... Replace seal... Press bearing on with like 5 or 10tonne of force on the press... Then press the new retainer on after that... Cheers, Tim
_________________ {DESCRIPTION} |
|||
| Top | |
|||
| Who is online |
|---|
Users browsing this forum: No registered users and 53 guests |
