Fordmods Logo

Rough idle 

 

Page 1 of 1 [ 4 posts ] 

 
 Post subject: Rough idle
Posted: Wed Dec 27, 2006 5:29 pm 
Stock as a Rock
Offline

Age: 39

Posts: 145

Joined: 18th May 2006

Ride: EA Falcon

Location: perth
WA, Australia

hey peeps

i have a 89 fairmont ghia. just serviced it all with new leads, plugs etc.

now went and had to tow my brothers lil excel on a trailer back to parents house, and now when its in drive, or reverse its really rough and stuttery.

Have i gone and cooked the 3 speed?


thanks lynx

 

_________________

1989 Fairmont Ghia
3.9L
5 Spd Manual
2.77 LSD
2.5" Mercury Sports exhaust
Extractors

Top
 Profile  
 
 
Posted: Thu Dec 28, 2006 12:52 am 
Stock as a Rock
Offline

Age: 39

Posts: 145

Joined: 18th May 2006

Ride: EA Falcon

Location: perth
WA, Australia

lol im a tard. was checking the engine bay over, and when i revved the engine some exhaust gas blew past the manifold gasket, so ive found the problem.

sounds good though, if it werent for the lack of power down low

 

_________________

1989 Fairmont Ghia
3.9L
5 Spd Manual
2.77 LSD
2.5" Mercury Sports exhaust
Extractors

Top
 Profile  
 
 
Posted: Wed Jan 10, 2007 1:49 am 
Stock as a Rock
Offline

Age: 39

Posts: 145

Joined: 18th May 2006

Ride: EA Falcon

Location: perth
WA, Australia

ok im not a tard. has been a lil while since that last post. replaced cat and all exhaust gaskets, cleaned isc, swapped MAP sensors, changed to a newer o2 sensor, and my car is still idleing and revving like shyte. im starting to get really annoyed now.

what else could it be? injecters, coil dying?


gggggggrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrrr

bloody ea

 

_________________

1989 Fairmont Ghia
3.9L
5 Spd Manual
2.77 LSD
2.5" Mercury Sports exhaust
Extractors

Top
 Profile  
 
 
Posted: Thu Jan 11, 2007 1:48 am 
Fordmods Newbie
Offline

Age: 62

Posts: 4

Joined: 5th Jan 2007

Ride: Au

Location: Wodonga
VIC, Australia

Go for the obvious mate. What did you do... Plugs and leads, Recheck them first, make sure plugs are correct type and gaps are right, check leads are on all the way and you haven't burnt out an end by not clipping on right. and don't assume that because they're new that they can't be stuffed. after that, check dissy cap and rotor.. but my guess is you'll find it before that.
Top
 Profile  
 
Display posts from previous:
Sort by  
 Page 1 of 1  [ 4 posts ] 

Who is online

Users browsing this forum: Google Adsense [Bot] and 40 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

 

 

It is currently Fri Apr 26, 2024 9:27 pm All times are UTC + 11 hours

 

 

(c)2014 Total Web Solutions Australia - Australian Web Hosting and Domain Names