|
flo5 |
|
||
|
How'd,
I've pulled an EEC-IV from an EB that I'm planning to put into a XF Falcon which will be converted to EFI at the same time. Following the EB II pinout diagram from a Haynes manual everything seems to match up except I have additional wires running to pins 6, 24 and 41 & 49. Pin 6 is a yellow wire going to a connector the same as the injectors and has a Black/White wire also. Pin 24 (White/Green) and Pin 41 (White/Light Blue) go to a 4-pin connector which has a wire cut already. Pin 49 (Grey/Light Blue) goes via the connector for the EFI and has a circular way like a earth to the body. Any help much appreciated. Cheers Fraser Attachment:
|
||
Top | |
Mad2 |
|
|||
|
if you can tell me what the pins are to - i can workout [hopefully?] what they are for.
|
|||
Top | |
flo5 |
|
||
|
How'd,
Pins 6, 24, 41 & 49. My ECU diagram has no wires on these pins so I'm lost and have no idea where they go other than they are all from under the hood. Cheers Fraser |
||
Top | |
Mad2 |
|
|||
|
flo5 wrote: Following the EB II pinout diagram from a Haynes manual everything seems to match up except I have additional wires running to pins 6, 24 and 41 & 49. Pin 6 is a yellow wire going to a connector the same as the injectors and has a Black/White wire also. - connection 735 Yellow = EB power steering switch [or without pwr steering is just a link] with the other wire being connection 359 Black/White at pin 46. Pin 24 (White/Green) and Pin 41 (White/Light Blue) go to a 4-pin connector which has a wire cut already. - nothing seems to show up re EB2, but re EB it shows - 24 = connection 189 and 41 = connection 264 are for the Centre Point Fuel Injection idle speed controller also known as CPFI do not confuse with MPFI [multi point fuel injection] as it has only two injectors in what looks like a carby. Pin 49 (Grey/Light Blue) goes via the connector for the EFI and has a circular way like a earth to the body. - connection 89 is for the HEGO earth Any help much appreciated. Cheers Fraser Attachment: 20240820_190332.jpg hopefully that above info is correct as it was fun deciphering what i was reading in the factory manual. are you sure on what you grabbed re EB2?. |
|||
Top | |
flo5 |
|
||
|
Delete
Last edited by flo5 on Thu Aug 22, 2024 7:34 pm, edited 1 time in total. |
||
Top | |
flo5 |
|
||
|
Thanks, looks like I might have a EB not a EB II wiring harness.
Cheers Fraser |
||
Top | |
Who is online |
---|
Users browsing this forum: No registered users and 4 guests |