Fordmods Logo

Datalogger Setup 


Page 6 of 6 [ 78 posts ] Go to page Previous  1, 2, 3, 4, 5, 6

 Post subject: Re: Datalogger Setup
Posted: Tue Nov 04, 2014 11:11 am 
Stock as a Rock

Posts: 143

Joined: 19th Oct 2007

Location: Adelaide
SA, Australia

After using the J3 to play with non fuel related parameters for the last couple of months, I set up the tech edge wideband over the weekend. Unfortunately I think I'm having some problems since it went in. I have random lean flatspots that weren't there before - the car will feel gutless and bog down with winlog showing an AFR in the 18s for a few seconds. This usually happens at low revs with medium load, e.g. normal driving. Also, the readouts for TPS and MAP are jumping up and down (e.g. throttle shows 0, 2, 1 % continually cycling).

I'm assuming this is all due to a bad earth of some sort, but I've followed the information earlier in this thread as best I can. Could anyone confirm if they've had similar problems, and perhaps exactly where they connected the signal and power grounds?
 Post subject: Re: Datalogger Setup
Posted: Thu Nov 06, 2014 1:01 pm 
Getting Side Ways
User avatar

Posts: 1134

Joined: 27th Feb 2005

Ride: Supercharged EF Fairmont

Location: T.I. Performance HQ
VIC, Australia

Check your 2J earth and the nbsim signal. If you have doubts, get a 2nd bung put in to keep running the original O2.




T.I. Performance - Performance Tuning for your Ford. J3 Chips, DIY Tuning Kits, Wideband O2 Controllers and much more!

 Post subject: Re: Datalogger Setup
Posted: Fri Feb 19, 2016 9:06 pm 
Fordmods Newbie

Age: 27

Posts: 2

Joined: 12th Feb 2016

Ride: ford el falcon v8

Location: wagga
NSW, Australia

anyone know the correct way to wire it up to a v8 my datalogger is running but and all that but its got a heating flash. I cant seem to get by this, help would be greatly appreciated thanks
Display posts from previous:
Sort by  
 Page 6 of 6  [ 78 posts ]  Go to page Previous  1, 2, 3, 4, 5, 6

Who is online

Users browsing this forum: No registered users and 8 guests

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum



It is currently Mon Oct 24, 2016 7:50 am All times are UTC + 11 hours



(c)2014 Total Web Solutions Australia - Australian Web Hosting and Domain Names