|
| syko4d |
|
|||
|
i just put a el head on my ed falcon as i blew a headgasket the head is a 94da head
now the exhaust manifold doesnt seem to line up and neither does the inlet manifold im using the eb plenum and standard exhaust manifold i didnt want to put the bbm on as i think its to much trouble is the exhaust and inlet different on the el head? i can put the exhaust manifold on it off the el tomorrow that should solve the exhaust but what do i do with the inlet?
_________________ now playing with a v8 to hahaha |
|||
| Top | |
|||
| MMD |
|
||
|
How far out is each manifold from lining up ?
|
||
| Top | |
||
| Steady ED |
|
|||
|
They are identical heads manifold fitment wise.
I have NFI what you are doing wrong to make them 'not line up'.
_________________ ED XR8 Sprint - S-Trim, V500, 249rwkw |
|||
| Top | |
|||
| syko4d |
|
|||
|
there only a couple of mil out but its enough to make it difficult the exhaust i can line up the first top bolt screw it in and the back top one but thats it the rest dont line up they have to come down and forward???
_________________ now playing with a v8 to hahaha |
|||
| Top | |
|||
| syko4d |
|
|||
|
i dont understand either ill try again tomorrow anyway
_________________ now playing with a v8 to hahaha |
|||
| Top | |
|||
| BenJ |
|
||
|
I had this prob with my extractors when I put them on. Start with a middle bolt and work your way out, but don't tighten any of them until you have them all started.
BenJ
_________________ BenJ's EB T5 DOHC Ghia Wagon - Current Ride |
||
| Top | |
||
| smiley235 |
|
|||
|
I had enough trouble trying to attach my exhaust manifold to the same head it came off. Might help if you can get some1 to force it in position as you get the bolts in position, it took be bloody hours.
_________________ 178.3 rwkw
|
|||
| Top | |
|||
| FordFairmont |
|
||
Posts: 6113 Joined: 8th May 2007 |
how about unbolting it from the cat first to bolt it to the head?
|
||
| Top | |
||
| snap0964 |
|
|||
|
The stock exh manifold has three studs and nuts that hold the 2 halves together - have a look at exh branches 3 & 4. They might be loose, causing them to swivel.
_________________ 96 XH Longreach 'S': LPG, Alarm, 3.23:1 LSD, Cruise, Trip Comp, ABS, Power Windows, Mid Series Dome Lt, Climate Ctrl |
|||
| Top | |
|||
| Paulmac |
|
||
|
Second the above two posts, my EB2 gear went straight onto an EL head. So one or both of the above listed possibilities would be the cause of your probs.
Also BenJ's advice re. bolting is good if you go middle, middle, end, end to hold the gaskets in place. You'll see what I mean. Cheers, Paul
_________________ What goes around, comes around. |
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: No registered users and 52 guests |
