|
| jetea |
|
||
|
Hi everyone...My EA Ghia has a factory 5 speed therefore it idles lower than an auto....Now my idle has stuffed up and is idling under 300rpm fluctuating lower and higher at different points of the start up and the drive. It even causes my car to stall sometimes then i turn the steering wheel all the way right or left.
I dont know wat 2 do and its killing me cause i want it running smoothly again. thanks
_________________ JETEA - ROARN8 - AUII Fairmont Ghia, V8, leather, sunroof, SAT NAV etc. 175KW |
||
| Top | |
||
| JOSE |
|
|||
|
is your ISC working? (when you turn on AC or turn the steering wheel the idle speed should go up a bit)
_________________ Because i can. |
|||
| Top | |
|||
| sexyr6 |
|
|||
|
most likely the ISC (idol Speed Controller if you didnt already know) just remone it and clean it out with carbie cleaner...
_________________
|
|||
| Top | |
|||
| sexyr6 |
|
|||
|
most likely the ISC (idol Speed Controller if you didnt already know) just remone it and clean it out with carbie cleaner...
_________________
|
|||
| Top | |
|||
| jetea |
|
||
|
cheers man...cause its doin my head in
where about is the controller?
_________________ JETEA - ROARN8 - AUII Fairmont Ghia, V8, leather, sunroof, SAT NAV etc. 175KW |
||
| Top | |
||
| Steady ED |
|
|||
|
jetea wrote: cheers man...cause its doin my head in Cylindrical looking thing on top of the throttle body, with two ?10mm? bolts in it.
where about is the controller? edit: unplug it, see if it makes a difference to idle. If it doesnt, it's more then likely fooked or blocked with carbon. Can clean it out with carby/brake cleaner or similar.
_________________ ED XR8 Sprint - S-Trim, V500, 249rwkw |
|||
| Top | |
|||
| evlmont |
|
||
|
hey my girlfriends mums eb has the same drama replaced old one with one from the wreckers but still doin the same thing can i use wd 40 or just plain fuel to clean it
_________________ my 95 ef fairmont 5 speed |
||
| Top | |
||
| MMD |
|
||
|
WD40 should be fine
from tech docs - the Best thing to do is fill the Passageways with turps, or WD40, then cover the holes, and shake thoroughly, to ensure that both the plunger, and passageways have been cleaned. |
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: No registered users and 12 guests |
