RPM RANGE 4000-8000

I doubt that would be on a head with std hydraulic set up

call surecam, custom grind on a new billet will be about $600 to $800.
and no you wont get one the week you ask for it.[/quote]
We don't want it next week.. Just like to know when and when they say next month !! Crowe etc have been saying that for months...
Actually off and on since Nov 06...[/quote]

surecam are pretty good. i think we waited about 2 weeks for our RB30 cam[/quote]


There was NO issue with surecam.. There was NO billet cams available..
"Anywhere" !! Including Kelford cams ..N.Z.. Apparently the billets are U.S made..

The first post would be perfect with a rough price range for each cam.

they range from about $150 to $450

Last edited by tickford_6 on Sun Jun 21, 2009 8:00 am, edited 1 time in total.

edit: i like pizza

Last edited by FordFairmont on Sun Jun 21, 2009 9:18 am, edited 1 time in total.

point taken

Last edited by tickford_6 on Mon Jun 22, 2009 6:11 pm, edited 1 time in total.

Is there a way I am am able to find out what type of cam i have in my car, all I know is that its a Wade cam and the idle is lumpy as f**k.

Sorry in advance if it's a ridiculous question haha.

Pull it out and start looking for part numbers

Holey crap those camtech cams r huge rev range 4000 to 8000 and min compression ratio of 11.0:1
Wow

hey all
im looking for advice on what cam i should get for my ef 6
i want better torque off the line to get me going nd then a mid range torque to keep it going lol
it will be a manual soon so i can go reasonby big but i dont wanna go massive just something tought
any ideas prices would be good to
cheers

Wade cam, Regrind about $150, 1673, has good mid to high end perfect for a manual. Have a look on there website.

thanks does it need new springs? or any com work?

Negative

Not that i know of

ok thanks for your help

Ok Im just starting to try and understand cams, and to be honest I dont know if need to understand them. I just want help finding the right one Dose this one sound ok guys



Its a camtech cam.

Cheers

need more info about your car and what type of driving you do

Ok mate. NF fairlane, T5 manual, AU I6 VCT engine but getting rid of the VCT. As for driving I just want the car to pull hard and fast, and still be able to drive relatively normal. Something that is borderline on being a rough idle. With the rev range on this one i thought it might be just what im looking for. 1800-5200 does this mean it will be sluggish and almost not drivable until you reach 1800? I plan to install a 3.45 lsd later on and also like to boost it later on down the track.

Cheers

hey all i was just wondering if anyone could tell me if they have used this cam and how it would run in a auto el (stock bar exhaust and boxed K&N pod with a C.A.I thru bonnet). i dont understand all the specs... its the third cam

thanks in advance, Paul

getting a wade 1673 cam done.... do i have to send it to wade to get the regrind done or am i able to get it done buy any workshop that has the tools to do it with?