|
| blakey72 |
|
||
|
I have an AU2 2001 XR8 ute (200Kw) and a few weeks ago I noticed a vibration/shudder creeping in. It happens just above idol up to around 1300rpm. If I give it a small boot from idol it doesn't really happen. Just light to normal acceleration. So...... I've changed plugs, leads, new engine mounts, checked gearbox mounts no luck. I took it to Ford and he put the computer on it and said it was the mass flow sensor. Changed that, still the same. Any ideas?
Cheers Blake. |
||
| Top | |
||
| XR9UTE |
|
||
|
hows your balancer?
|
||
| Top | |
||
| blakey72 |
|
||
|
Yeah that's what I'm thinking. Balancer. Looks fine but who knows. Is there visible signs if it's damaged?
|
||
| Top | |
||
| XR9UTE |
|
||
|
I'll send you pic of where your timing marks should be in relation to the encoder teeth.
|
||
| Top | |
||
| blakey72 |
|
||
|
Thanks that would be great.
|
||
| Top | |
||
| XR9UTE |
|
||||
|
So, TDC should line up with the leading edge of the 3rd tooth after the missing tooth on the encoder wheel...
|
||||
| Top | |
||||
| blakey72 |
|
||
|
XR9UTE wrote: So, TDC should line up with the leading edge of the 3rd tooth after the missing tooth on the encoder wheel... Awesome XR9UTE. I'll go check it out. Thanks very much. |
||
| Top | |
||
| blakey72 |
|
||
|
You were spot on XR9UTE. On the leading edge of the 3rd tooth it lines up with 35 degrees. Probably not good. Thanks again
|
||
| Top | |
||
| XR9UTE |
|
||
|
No worries man. Glad to help.
|
||
| Top | |
||
| Who is online |
|---|
Users browsing this forum: No registered users and 24 guests |