Fordmods Logo

ICC issues 

 

Page 1 of 1 [ 4 posts ] 

 
 Post subject: ICC issues
Posted: Sat Sep 22, 2018 3:38 pm 
Fordmods Newbie
Offline

Age: 59

Posts: 3

Joined: 22nd Sep 2018

Ride: BF Falcon XR6

Location: Robina
QLD, Australia

Just a quick question for anyone who knows the answer...
Radio, HVAC, Traction Controls, Door locks, Dome Lights and Iffo (petrol, mileage left, etc) don't work on ICC unit. Instruments, wipers, horn, everything else works. If I replace the WHOLE ICC and use my present BEM, will everything work, or am I screwed????

I have used FORSCAN and run OnDemand Self tests with U1900 DTC error only.

Thanks!!!

Rod
Top
 Profile  
 
 
 Post subject: Re: ICC issues
Posted: Mon Sep 24, 2018 9:16 pm 
Technical Contributor
Offline

Posts: 532

Joined: 13th Jul 2013

Location: Campbelltown
NSW, Australia

icc needs programming to vin. of vehicle with scantool genuine or some aftermarket units.

Have you checked all fuses in interior fuse box.
Check reverse lights work.
Remove icc and refit after resetting connection at rear of icc by pulling connection plug towards you slightly until it clicks.

Verify model is a BF.....
Top
 Profile  
 
 
 Post subject: Re: ICC issues
Posted: Wed Oct 10, 2018 10:56 pm 
Fordmods Newbie
Offline

Age: 59

Posts: 3

Joined: 22nd Sep 2018

Ride: BF Falcon XR6

Location: Robina
QLD, Australia

Yes all is working. I do have another question, though..... If I have a replacement BEM and 2 original keys, can I program the original keys to the replacement BEM using Forscan???
Top
 Profile  
 
 
 Post subject: Re: ICC issues
Posted: Sat Oct 13, 2018 8:02 pm 
Technical Contributor
Offline

Posts: 532

Joined: 13th Jul 2013

Location: Campbelltown
NSW, Australia

rodders591 wrote:
Yes all is working. I do have another question, though..... If I have a replacement BEM and 2 original keys, can I program the original keys to the replacement BEM using Forscan???



not sure myself as to what is possible with "forscan" I think you need to purchase a limited liscence to enable you to program 2 keys to new or existing BEM you then need to relink BEM and ECU ie. (parameter reset)-
hopefully this question can be cleared up by some one who has previously used "forscan" for this purpose.

suggest you swap old BEM for replacement unit before attempting this to allow you to swap back to original if it doesn't work and then also carry out parameter reset as mentioned above.

what is problem with existing BEM?
Top
 Profile  
 
Display posts from previous:
Sort by  
 Page 1 of 1  [ 4 posts ] 

Who is online

Users browsing this forum: No registered users and 6 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

 

 

It is currently Mon Aug 26, 2019 2:05 pm All times are UTC + 11 hours

 

 

(c)2014 Total Web Solutions Australia - Australian Web Hosting and Domain Names